New Complete Myford Super7 Cross Slide With Adjusting Screws & Gibstrips A2060/2

New Complete Myford Super7 Cross Slide With Adjusting Screws & Gibstrips A2060/2

New Complete Myford Super7 Cross Slide With Adjusting Screws & Gibstrips A2060/2
New Myford Super 7 Cross Slide - A2060/2. Super 7 Cross Slide Comes Complete With All Adjusting Screws And Gib Strips. This cross slide comes without the holes for the end plate drilled. This is because the height of this can vary from lathe to lathe, and to get the optimal performance, you should do this when the cross slide is on your lathe. Failure to do this correctly can cause excessive wear in the feednut, as the feedscrew and bracket will not be aligned properly. First, assemble the feedscrew in the bracket, and slide your new cross slide in place (on to the dovetail). Screw the feedscrew into the feednut, so that the bracket is now pushed up against the cross slide. Next, use some toolmakers clamps to align the bracket, and make sure that it is at the correct height. Spot through the holes of the bracket for drilling. Next, using a stand drill, drill the holes into the cross slide (the holes should go in roughly 3/4).

These were originally tapped 2BA, but M5 will do just as well if this is easier to come by. PLEASE NOTE - THIS WILL NOT FIT THE OTHER MYFORD LATHES (SUCH AS THE ML7, ML7R, ML10 OR 254). The item "New Complete Myford Super7 Cross Slide With Adjusting Screws & Gibstrips A2060/2" is in sale since Tuesday, July 25, 2017. This item is in the category "Business, Office & Industrial\CNC, Metalworking & Manufacturing\Metalworking Equipment\Metalworking Lathes".

The seller is "myford_ltd" and is located in Mytholmroyd, West Yorkshire. This item can be shipped to North, South, or Latin America, all countries in Europe, Japan.


New Complete Myford Super7 Cross Slide With Adjusting Screws & Gibstrips A2060/2


Homepage   Sitemap   Contact Us   Privacy Policies   Terms of Use